Car chassis wire harness wholesalers introduces the manufacture of electronic wholesalers connectors, from design to finished product, can be divided into two parts: metal and plastic. In addition to the material selection, the metal part is the main work of electroplating and die. The work of the mold is the mold design, mold opening and injection. Molding, and then with the metal component group to form an electronic connector. The electronic connector is used in electrical products. As the name suggests, it acts as a connection for electronic signals or components. It is a multi-component or assembled product and is covered with metal sheets. Key technologies such as surface plating, precision machining and plastic molding. As the transmission and connection of electronic signals, if there is a problem with the electronic connector, it will lead to the partial selection of materials, and the quality of the plating and die will affect the quality of the product. Of course, the plastic part is also the same. Its manufacturing includes five major technologies: 1. Die technology. 2. Injection molding technology 3. Electroplating technology. 4. Assembly technology 5. Detection technology. Since the trend of connectors is thin and short, and SMT, Therefore, the various manufacturing technologies required also need to improve the accuracy of their requirements, and the precise concept of the manufacturer must be changed to create a precision connector, otherwise the connector at the end Market, will be eliminated, because quality can not compete electronic components and even entire equipment failure. The connector includes a terminal and the entire plastic part of two major terminals. If you want to learn more about Motorcycle harness wholesalers,you can contact us.